Cardan with sensor (Trendelenburg drive)
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
137
15.15
Cardan with sensor (Trendelenburg drive)
Important: assembly requires serial number. Note chapter 27 on
Disassembly
1. Prepare the operating table (see chapter 7 on page 29).
2. Switch off the operating table and disconnect the internal
power supply (see chapter 10 on page 33).
3. Remove the table top (see chapter 12.1 on page 38).
4. Remove the bellows (see chapter 14.3 on page 78).
5. Be sure to note the cable routing.
Remove the cable attachment for the sensor cable under the
mounting plate.
6. Unscrew the Trendelenburg drive [3] from the mounting
plate [1] (6 screws).
7. Unscrew the outer bearing [4] from the drive assembly
(4 screws).
Carefully knock (nylon hammer) the outer bearing [4] from the
cardan [5] and the bearing plate [6].
CAUTION
Risk of material damage! Handle the power sensor
(cardan) with care.
The power sensor is a sensitive component and can easily break.
Follow these instructions when handling the sensor:
– Do not allow the sensor to touch magnets.
– Do not jolt the sensor (e.g. by knocking off attached parts with a
hammer).
– Always store the sensors for the different drives separately from
one another and make sure there is sufficient space between
them.
– Do not open the sensor or remove it from the cardan.
– Do not allow the sensor to touch e.g. a micrometer screw or
caliper gauge; they might be magnetized.
– Do not twist the plastic parts on the sensor or reposition them in
any way.
8.
CAUTION
Risk of material damage if the drive is twisted.
Do not twist the freestanding drive assembly after removing it
from the mounting plate. The motor calibration is lost and must
be repeated if the spindle is twisted.
Summary of Contents for TruSystem 7000
