Trumpf TruSystem 7000, Service Manual

Page: 138 / 306

Cardan with sensor (Trendelenburg drive)
138
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
9. Carefully knock (nylon hammer) the cardan [5] with the two
bearing blocks [7] from the inner bearing [8].
10. Remove the bearing blocks [7] from the cardan [5].
Assembly 1. Slide both the right and left bearing blocks on the short shafts
(without sensor) of the cardan.
2. Note the original mounting position of the cardan. Do not twist
the spindle on the drive.
Guide the sensor cable through the inner bearing and insert
the cardan into the bearing. Use blow-back-proof nylon
hammer, if needed.
3. Attach the outer bearing to the cardan and the bearing plate
(4 screws). Use blow-back-proof nylon hammer, if needed.
4. Attach the mounting plate to the bearing blocks of the drive
assembly (6 screws).
5. Restore the sensor cable to its original position and
connection.
6. Remove the support between the suspension plate and the
mounting plate.
7. Attach the bellows (see chapter 14.3 on page 78).
8. Attach the table top (see chapter 12.1 on page 38).
9. Attach the cover to the center box (see chapter 12.3 on
page 41).
10. Attach the pad plate to the seat section bars (see chapter 12.2
on page 40).
11. Establish the internal power supply, close the column cover
and turn on the operating table (see chapter 10 on page 33).
12. Put on the pad.
TEST
Perform function test and final check.