Emergency adjustment for the lift
34
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
11
Emergency adjustment for the lift
The column cannot be moved upward if there is a defect in the lift
motor. A manual emergency adjustment has to be performed to
access the column pot. Emergency adjustment is not possible if the
telescopic spindle is defective.
1. Prepare the operating table (see chapter 7 on page 29).
2. Remove the column cover (see chapter 14.1 on page 75).
3. Secure the star wheel (#1800121) on the left side rail
1)
of the
seat section.
Release the brake on the operating table (unlock the
operating table).
5. Switch off the operating table and disconnect the internal
power supply (see chapter 10 on page 33).
6. Slide the multifunction tool [1] mounted as a T under the table
base [2].
7. Safety note: The operating table is extremely heavy; take extra
care not to strain your back when turning it on its side. A
second person is needed to turn the operating table on its side.
With the help of another person, lay the operating table over
onto the multifunction tool (side with the column keypad points
down) and set it on the star wheel.
After placing the table on its side, do not activate the
hydraulics system to prevent air from seeping into the hydraulic
hoses.
1)
Side with the column keypad
4.
CAUTION
Risk of material damage!
The major force required to turn the table on its side can break
the extended foot locks of the brake. The operating table must
be unlocked before turning it on its side.
CAUTION
Risk of injury due to electric shock!
The battery plugs cannot be disconnected when the
operating table is set in the lowest lifting position. In this case,
work must be done under voltage. Make sure that no
functions (e.g., lift, tilt) are carried out on the operating table.
Summary of Contents for TruSystem 7000
