Teledyne T100, Instruction Manual, Page: 86 / 404

Operating Instructions Teledyne ML - T100 UV Fluorescence SO2 Analyzer
86
If the calibration password ( 100 ) is enabled, the following control button sequence will
be required to enter one of the calibration modes:
SAMPLE ENTER SETUP PASS : 0
0 0 0 ENTR EXIT
SAMPLE RANGE = 500.0 PPB SO2 =XXX.X
< TST TST > CAL CALZ CALS SETUP
M-P CAL RANGE = 500.0 PPB SO2 =XXX.X
< TST TST > ZERO CONC EXIT
Prompts
password
number
SAMPLE ENTER SETUP PASS : 0
1 0 1 ENTR EXIT
Press
individual
buttons to set
101
Continue calibration process …
Figure 4-5: SETUP
– Enter Calibration Mode Using Password
4.4. SETUP MODE
The SETUP mode contains a variety of choices that are used to configure the analyzer’s
hardware and software features, perform diagnostic procedures, gather information on
the instrument’s performance and configure or access data from the internal data
acquisition system (DAS). For a visual representation of the software menu trees, refer
to Appendix A-1.
The areas access under the Setup mode are divided between Primary and Secondary:
Table 4-4: Primary Setup Mode Features and Functions
MODE OR FEATURE
CONTROL
BUTTON
DESCRIPTION
MANUAL
SECTION
Analyzer Configuration CFG Lists key hardware and software configuration information. 4.5
Auto Cal Feature ACAL
Used to set up and operate the AutoCal feature.
Only appears if the analyzer has one of the internal valve
options installed.
6.8
Internal Data Acquisition
(DAS)
DAS Used to set up the DAS system and view recorded data. 5.2
Analog Output Reporting
Range Configuration
RNGE
Used to configure the output signals generated by the
instrument
’s Analog outputs.
4.6
Calibration Password Security PASS Turns the calibration password feature ON/OFF. 4.3.2
Internal Clock Configuration CLK
Used to Set or adjust the instrument’s internal clock.
4.5.1
Advanced SETUP features MORE This button accesses the instruments secondary setup menu.
See
Table 4-5