Teledyne T100, Instruction Manual, Page: 85 / 404

Teledyne ML - T100 UV Fluorescence SO2 Analyzer Operating Instructions
85
4.3.2. SETUP
– PASS: CALIBRATION PASSWORD SECURITY
The T100 calibration functions may be password protected for to prevent inadvertent
adjustments. When the calibration password has been enabled using the
PASS menu
item found under the Setup Menu (refer to below), the system will prompt the user for a
password anytime that
CAL , CALZ or CALS is activated.
The default status of the calibration password is OFF . To enable the calibration
password press:
SAMPLE ENTER SETUP PASS : 818
8 1 8 ENTR EXIT
SAMPLE RANGE = 500.0 PPB SO2 =XXX.X
< TST TST > CAL SETUP
SETUP PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SETUP CAL. PASSWORD ENABLE: OFF
OFF ENTR EXIT
SETUP PASSWORD ENABLE: ON
ON ENTR EXIT
SETUP PASSWORD ENABLE: ON
ON ENTR EXIT
ENTR accepts
the change
EXIT ignores
the change
Toggles
password
status On/Off
ENTR accepts
displayed
password value
EXIT returns to
SAMPLE display
CAL. PASSWORD
default state is
OFF
Figure 4-4: SETUP
– Enable Calibration Password Security