Teledyne T100, Instruction Manual, Page: 58 / 404

Getting Started
Teledyne ML - T100 UV Fluorescence SO2 Analyzer
58
3.5.1. BASIC CONNECTIONS
Refer to Figure 3-4 and Table 3-2 while making the pneumatic connections as follows:
SAMPLE inlet Connect ¼” gas line not more than 2 m long, from sample gas
source to this inlet.
When no zero/span/shutoff valve options, also connect line from
calibration gas source to this inlet, but only when a calibration
operation is actually being performed.
EXHAUST outlet
Connect exhaust line made of PTEF tubing; minimum O.D ¼”, to
this fitting. The exhaust line should be no longer than 10 meters,
and should lead outside the shelter or immediate area surrounding
the instrument.
Figure 3-16 and Figure 3-17 illustrate pneumatic connections for two of the possible
basic configurations.
Source of
SAMPLE GAS
(Remove during
calibration)
VENT
MODEL T701
Zero Gas
Generator
Calibrated
SO
2
Gas
at
span gas
concentration
VENT
here if input
is pressurized
SAMPLE
EXHAUST
Chassis
Figure 3-16: Pneumatic Connections
–Basic Configuration–Using Bottled Span Gas