Technogym BIOSTRENGTH LINE, Service Maintenance Manual

Page: 630 / 646

BIOSTRENGTH LINE: Service & Maintenance manual - rev. 2.1
Page 9.22
9.6. EDITING THE WORKING PARAMETERS
The procedure for editing the machine's working parameters, to set the desired values (for example,
after replacing the CPU board) may be activated when the machine is in stand-by mode by pressing
the keys “1”, “3” and “4” simultaneously. To access this procedure, you must enter the password
that protects against unauthorized access.
P A S S W O R D =
*
After entering the password “2709” and pressing “Enter” to continue, the machine begins to offer
the configurable parameters in sequence, showing their current value. Press the "Enter" key to move
on to the next parameter; to change a value, simply type in the new value desired. Or, you may press
the “Clear” key to quit the procedure.
All data are expressed in 9-digit numbers. This means that to edit an existing 4-digit
number, you must first enter 5 digits to reset the value, then enter the desired value.
The following information will be displayed on the LED matrix at this point:
9.6.1. W
EIGHT STACK MOTOR RUNNING TIME
This is the total number of seconds for which the weight stack motor has been used.
M O T O R W E I G H T O N
S E C . X X X X X X X X X
Change the value shown or press
ENTER to continue.
9.6.2. W
EIGHT STACK MOTOR TEST CYCLES
The number of cycles performed by the seat motor during the test procedure described in paragraph
6.2. “Automatic components test”.
M O T O R W E I G H T
C Y C L E S : X X X X X X X X X
Change the value shown or press
ENTER to continue.
9.6.3. N
UMBER OF RELAY SWITCHING CYCLES TO MOVE THE WEIGHT STACK
MOTOR UPWARD
The number of times the weight stack motor interface board relays have switched in order to move
the motor upward.
W E I G H T R E L A Y U P
C Y C L E S : X X X X X X X X X
Change the value shown or press
ENTER to continue.