Stanley AV 5, Instruction And Service Manual

Page: 4 / 314

ENGLISH ORIGINAL INSTRUCTION
3
This instruction manual must be read by any person installing or operating this tool with particular atten-
tion to the following safety warnings and instructions.
Always wear impact-resistant eye protection during operation of the tool. The grade of protection requi-
red should be assessed for each use.
Use of the tool can expose the operator’s hands to hazards, including crushing, impacts, cuts and abrasi-
ons and heat. Wear suitable gloves to protect hands.
Use hearing protection in accordance with employer’s instructions and as required by occupational
health and safety regulations.
1. SAFETY DEFINITIONS
The defi nitions below describe the severity for each signal word. Please read the manual and pay attention to these
symbols.
DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death
or serious injury.
WARNING:
Indicates a potentially hazardous situation which, if not avoided,
could
result in
death or serious injury
.
CAUTION:
Indicates a potentially hazardous situation which, if not avoided,
may
result in
minor or moderate injury.
CAUTION:
Used without safety alert symbol indicates a potentially hazardous situation
which, if not avoided,
may
result in property damage.
Improper operation or maintenance of this product could result in serious injury and property damage.
Read and understand all warnings and operating instructions before using this equipment. When using
power tools, basic safety precautions must always be followed to reduce the risk of personal injury.
SAVE ALL WARNINGS AND INSTRUCTIONS FOR FUTURE REFERENCE.
1.1 GENERAL SAFETY RULE
y
For multiple hazards, read and understand the safety instructions before installing, operating, repairing, maintai-
ning, changing accessories on, or working near the tool. Failure to do so can result in serious bodily injury.
y
Only qualifi ed and trained operators must install, adjust or use the tool.
y
DO NOT use outside the design intent of placing STANLEY Engineered Fastening Blind Rivets.
y
Use only parts, fasteners, and accessories recommended by the manufacturer.
y
DO NOT modify the tool. Modifi cations can reduce the eff ectiveness of safety measures and increase the risks to the
operator. Any modifi cation to the tool undertaken by the customer will be the customer’s entire responsibility and
void any applicable warranties.
y
Do not discard the safety instructions; give them to the operator.
y
Do not use the tool if it has been damaged.
y
Prior to use, check for misalignment or binding of moving parts, breakage of parts, and any other condition that
aff ects the tool’s operation. If damaged, have the tool serviced before using. Remove any adjusting key or wrench
before use.
y
Tools shall be inspected periodically to verify that the ratings and markings required by this part of ISO 11148 are
legibly marked on the tool. The employer/user shall contact the manufacturer to obtain replacement marking labels
when necessary.
y
The tool must be maintained in a safe working condition at all times and examined at regular intervals for damage
and function by trained personnel. Any dismantling procedure will be undertaken only by trained personnel. Do
not dismantle this tool without prior reference to the maintenance instructions.
1.2 PROJECTILE HARZARDS
y
Disconnect the tool from the hydraulic pump unit before performing any maintenance, attempting to adjust, fi t or
remove a nose assembly or accessories.
y
Be aware that failure of the workpiece or accessories, or even of the inserted tool itself can generate high-velocity
projectiles.