NCK alarms
11/2006
Overview of Alarms
2-37
©
Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
4027
NOTICE! MD %1 was also changed for the other axes of axis container
%2
Parameters:
%1 = String: MD identifier
%2 = Axis container number
Definitions:
Message to the user indicating that the machine data change for the axis was also performed for all
other axes in the same container.
Reaction:
Alarm display.
Remedy:
None
Program
Continuation:
Clear alarm with the Delete key or NC START.
4028
Attention! The axial MDs of the axes of the axis containers were
matched.
Definitions:
Note for the user, that the machine data of the axis were matched in the axis containers.
Reaction:
Alarm display.
Remedy:
None
Program
Continuation:
Clear alarm with the RESET key. Restart part program
4029
NOTICE! The axial MDs in axis container %1 will be matched on the next
power-up
Parameters:
%1 = Axis container number
Definitions:
Message to the user indicating that the machine data of the axes in the axis container will be matched
on the next power-up. An axis container allows axes to be exchanged between channels and NCUs.
To ensure that no conflicts arise, the axes within the same axis container must have a similar behavior.
The first axis in the axis container determines which machine data have to be the same for the other
axis in the axis container.
Reaction:
Alarm display.
Remedy:
None
Program
Continuation:
Clear alarm with the Delete key or NC START.
4030
Channel %1 axis identifier missing in machine data %2[%3]
Parameters:
%1 = Channel number
%2 = String: MD identifier
%3 = Index: MD array
Definitions:
An axis identifier is expected for the displayed MD in accordance with the axis configuration in the MD
20070 AXCONF_MACHAX_USED and 20050 AXCONF_GEOAX_ASSIGN_TAB.
Reaction:
NC not ready.
Mode group not ready, also effective for single axes
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy:
Please inform the authorized personnel/service department. Check axis configuration and enter the
missing identifier into the MD or, should the axis not exist, specify for this channel axis the machine
axis 0 in the channel-specific MD 20070 AXCONF_MACHAX_USED. If this concerns a geometry axis
that is not to be used (this applies only for 2-axis machining, e.g. on lathes), then channel axis 0 must
be entered additionally in the channel-specific MD 20050 AXCONF_GEOAX_ASSIGN_TAB.
Program
Continuation:
Switch control OFF - ON.
