Overview of Alarms
11/2006
NCK alarms
2-238
©
Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
14542
Channel %1 block %2 contour tool: the min. limit angle has not been
programmed
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
On defining a contour tool, either no limit angle must be indicated, or both the minimum and the
maximum limit angle must be programmed once for each.
Reaction:
Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy:
Change tool definition.
Program
Continuation:
Clear alarm with NC START or RESET key and continue the program.
14543
Channel %1 block %2 contour tool: the max. limit angle has not been
programmed
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
On defining a contour tool, either no limit angle must be indicated, or both the minimum and the
maximum limit angle must be programmed once for each.
Reaction:
Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy:
Change tool definition.
Program
Continuation:
Clear alarm with NC START or RESET key and continue the program.
14544
Channel %1 block %2 contour tool: edge D%3 is not positioned between
the two border edges
Parameters:
%1 = Channel number
%2 = Block number, label
%3 = Edge number, label
Definitions:
On defining a form tool with limit, all edges must be positioned between the edge with the minimum
limit angle and the edge with the maximum limit angle when rotating counter-clockwise.
Reaction:
Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy:
Change tool definition.
Program
Continuation:
Clear alarm with NC START or RESET key and continue the program.
