Explanation:
The start point for repetition of the program part with CALL <program name> BLOCK <start label> TO <end label> has
not been found or the same program part repetition has been called recursively.
Reaction:
Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy:
Check the start and end labels for programming repetition in the user program.
Programm
continuation:
Clear alarm with NC START or RESET key and continue the program.
14085
[Channel %1: ] Block %2 instruction not allowed
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
The instruction 'TML()' may only be used in the subprogram, which replaces the T command.
Reaction:
Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy:
Modify part program.
Programm
continuation:
Clear alarm with NC START or RESET key and continue the program.
14088
[Channel %1: ] Block %2 axis %3 doubtful position
Parameters:
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Explanation:
An axis position larger than 3.40e+38 increments has been programmed. This alarm can be suppressed with bit11 in
MD11410 $MN_SUPPRESS_ALARM_MASK.
An axis position larger than 3.40e+38 increments has been programmed.
Reaction:
Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy:
Modify part program.
Programm
continuation:
Clear alarm with NC START or RESET key and continue the program.
14091
[Channel %1: ] Block %2 illegal function, index %3
Parameters:
%1 = Channel number
%2 = Block number, label
%3 = Index
SINUMERIK 808D ADVANCED alarms
5.2 NCK alarms
Diagnostics Manual
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
191
