Application Specification
1
of 22
© 2023 TE Connectivity Ltd. family of companies.
All Rights Reserved.
*Trademark
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product, and/or company names may be trademarks of their respective owners.
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at
114-106497
13 DEC 23
Rev 5
NOTE
All numerical values are in metric units [with U.S. customary units in brackets]. Dimensions are in millimeters [and inches].
Unless otherwise specified, dimensions have a tolerance of ±0.13 [±.005] and angles have a tolerance of ±2°. Figures and
illustrations are for identification only and are not drawn to scale.
1.
INTRODUCTION
This specification covers the requirements for application of Signal Grace Inertial (SGI) 1.25 & 1.50 connector
system includes SMT header assembly and plug assembly used in the wire-to-board interconnections, cap
assembly and plug assembly used in the wire-to-wire interconnections.
The SGI 1.25 connector system is available in 2 through 18 positions for single row, 20/22/30/40 positions for
dual row, and SGI 1.50 connector system is available in 2 through 12 positions for single row, 4 through 18
positions for dual row. Wire size ranges from 26 to 30 AWG for 1.25mm pitch connector, and 24 to 28 AWG for
1.50mm pitch connector.
When corresponding with TE Connectivity Personnel, use the terminology provided in this specification to
facilitate your inquiries for information. Basic terms and features of this product are provided in Figure 1.
SGI 1.25 Single Row
SGI 1.25 & 1.50 Connector System
Header Assembly
SGI 1.25 Single Row (5pos shown)
Plug Housing
SGI 1.25 Single Row (5pos shown)
Locking Latch
Mating Face
Mating Face
Wire Cavity
Cap Housing
SGI 1.25 Single Row (10pos shown)
Mating Face
PRELIMINARY
