14401
[Channel %1: ] Block %2 transformation not available. Error %3.
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
The required transformation is not available. The cause of the error is explained in detail by the error code.
1: No transformations are available.
2: No transformations of the type "inclined axis" are available.
3: No orientation transformations are available.
4: No transmit transformations are available.
5: No tracyl transformations are available.
6: No chained transformations are available.
22: The required transformations of the type "inclined axis" were not found.
23: The required orientation transformations were not found.
24: The required transmit transformations were not found.
25: The required tracyl transformations were not found.
26: The required chained transformations were not found.
40: An attempt was made to activate a transformation defined by kinematic chains. However, no such transformations
have been enabled (MD18866 $MN_MM_NUM_KIN_TRAFOS is zero).
41: No transformation name (first call parameter) was specified for the transformation call TRAFOON.
42: An attempt was made to activate a transformation defined by kinematic chains. However, no such transformation
with the specified name was found.
43: An attempt was made to activate a transformation defined by kinematic chains whose name had been changed since
the last activation. Changed transformation data does not become active until after a NEWCONF or RESET.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Error codes 1 to 6 indicate that the control does not contain the requisite software. The transformation cannot even be
activated by setting machine or option data.
For the remaining error codes:
Modify part program; program defined transformations only.
Check MD24... $MC_TRAFO_TYPE_... (assigns the transformation to the part program operation).
Programm
continuation:
Clear alarm with the RESET key. Restart part program
14402
[Channel %1: ] Block %2 spline active at transformation change
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
A change of transformation is not allowed in a spline curve section. A series of spline blocks must be concluded.
Reaction:
Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy:
Modify part program.
Programm
continuation:
Clear alarm with NC START or RESET key and continue the program.
14403
[Channel %1: ] Block %2 preprocessing and main run might not be synchronized
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
Positioning axis runs cannot be accurately calculated beforehand. Consequently, the position in the Machine (MCS) is not
known exactly. It might therefore be possible that a change in the multiple significance of the transformation has been
performed in the main run although no provision was made for this in the preprocessing run.
Reaction:
Alarm display.
SINUMERIK 808D ADVANCED alarms
5.2 NCK alarms
Diagnostics Manual
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
205
