10765
[Channel %1: ] Block %2 3D tool radius compensation not possible
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
This alarm occurs when an attempt is made to activate the 3D tool radius compensation even though the option required
for this is not fitted in the control.
Reaction:
Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy:
The option cannot be activated by altering machine data because the necessary code is not physically available.
Programm
continuation:
Clear alarm with NC START or RESET key and continue the program.
10770
[Channel %1: ] Block %2 change of corner type due to change of orientation with active tool radius
compensation
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
The type of a corner (inside or outside corner) depends not only on the programmed path but also on the tool orientation.
For this purpose, the programmed path is projected in the plane perpendicularly to the actual tool orientation and the corner
type is determined there. If a change in orientation is programmed (in one or several blocks) between two traversing blocks,
resulting in the type of corner at the end of the first traversing block being different from that at the start point of the second
block, the above error message is issued.
Reaction:
Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy:
Modify part program.
Programm
continuation:
Clear alarm with NC START or RESET key and continue the program.
10776
[Channel %1: ] Block%2 axis %3 must be geometry axis if tool radius compensation is active
Parameters:
%1 = Channel number
%2 = Block number, label
%3 = Axis name
Explanation:
This alarm occurs when an axis that is required for tool radius compensation is not a geometry axis. With CUT2DF, the
axis can be a positioning axis perpendicular to the machining plane; with all other types of compensation (CUT2DF,
CUT3DC, CUT3DF, CUT3DFF), all geometry axes must be operated as such.
Reaction:
Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy:
Modify part program.
On selection of G41/42, the axes involved must be known as GEOAX in the channel. It is possible by programming
GEOAX() or G91 G0 X0 Y0 in the block prior to G41/42.
Programm
continuation:
Clear alarm with NC START or RESET key and continue the program.
SINUMERIK 808D ADVANCED alarms
5.2 NCK alarms
Diagnostics Manual
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
121
