Explanation:
One of the following programming errors has occurred:
1. The keyword WAITP(x) "Wait with the block change until the specified positioning axes has reached its end point", was
used for an axis that is not a positioning axis.
2. G74 "Reference point approach from the program" was programmed for a spindle. (Only axis addresses are permissible.)
3. The keyword POS/POSA was used for a spindle. (For spindle positioning, keywords SPOS and SPOSA should be
programmed.)
4. If the alarm occurs for the function "Thread tapping without compensating chuck " (G331) the following reasons are
conceivable:
- The master spindle is not in position-controlled operation.
- Incorrect master spindle
- Master spindle without encoder
5. An axis name that is no longer available has been programmed, e.g. when using axial variables as index. Or it was
programmed as index NO_AXIS.
6. If 14092 is output as note for alarm 20140 motion synchronized action: traverse the command axis, then the the following
causes are possible:
- The axis is presently being traversed by the NC program.
- An overlaid movement is active for the axis.
- The axis is active as slave axis of a coupling.
- An interpolation compensation such as a temperature compensation is active for the axis.
7. PRESETON/ PRESETONS were programmed for an unknown channel axis.
Reaction:
Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy:
- Correct the part program according to which of the above errors is involved.
- Program SPOS.
- Set the correct master spindle with SETMS.
Programm
continuation:
Clear alarm with NC START or RESET key and continue the program.
14093
[Channel %1: ] Block %2 path interval <= 0 with polynominal interpolation
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
In the polynomial interpolation POLY, a negative value or 0 has been programmed under the keyword for the polynomial
length PL=...
Reaction:
Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy:
Press the NC Stop key and select the function "Correction block" with the softkey PROGRAM CORRECT. The correction
pointer positions on the incorrect block.
Correct the value given in PL = ...
Programm
continuation:
Clear alarm with NC START or RESET key and continue the program.
14094
[Channel %1: ] Block %2 polynominal degree greater than 3 programmed for polynominal
interpolation
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
The polynomial degree in the polynomial interpolation is based on the number of programmed coefficients for an axis. The
maximum possible polynomial degree is 3, i.e. the axes are according to the function:
f(p) = a0 + a1 p + a2 p2 + a3 p3
The coefficient a0 is the actual position at the start of interpolation and is not programmed!
SINUMERIK 808D ADVANCED alarms
5.2 NCK alarms
Diagnostics Manual
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
193
