Ronde & Schwarz 1304.0004.03, User Manual

Page: 82 / 1076

Applications, Measurement Channels, and Result Displays
R&S
®
FPL1000
82 User Manual 1178.3370.02 ─ 09
Switching between channel setups
When you switch to a new channel setup, a set of parameters is passed on from the
current channel setup to the new one:
●
Center frequency and frequency offset
●
Reference level and reference level offset
●
Attenuation
After initial setup, the parameters for the channel setup are stored upon exiting and
restored upon re-entering the channel setup. Thus, you can switch between measure-
ments quickly and easily.
Defining a channel setup ...............................................................................................82
└ New Channel Setup ........................................................................................ 83
└ Replace Current Channel Setup ..................................................................... 83
└ Duplicate Current Channel ..............................................................................83
Closing a channel setup ................................................................................................83
Defining a channel setup
To start a new channel setup or replace an existing one, select the corresponding
application in the "Mode" dialog box.
Note: The channel setups are labeled with the application name. If that name already
exists, a sequential number is added. You can change the name of the channel setup
by double-tapping the name in the channel setup bar and entering a new name.
For an overview of default names see
INSTrument:LIST?
on page 620.
Remote command:
INSTrument[:SELect]
on page 622
Defining Channel Setups