Rohde & Schwarz 1430.0105K02, User Manual

Page: 16 / 206

Getting Started
R&S
®
NRT2
16 User Manual 1178.5550.02 ─ 04
Electromagnetic compatibility classes
The electromagnetic compatibility (EMC) class indicates where you can operate the
product. The EMC class of the product is given in the data sheet under "General data".
●
Class B equipment is suitable for use in:
– Residential environments
– Environments that are directly connected to a low-voltage supply network that
supplies residential buildings
●
Class A equipment is intended for use in industrial environments. It can cause
radio disturbances in residential environments due to possible conducted and radi-
ated disturbances. It is therefore not suitable for class B environments.
If class
A equipment causes radio disturbances, take appropriate measures to
eliminate them.
3.1.4 Setting Up the Product
See also:
●
"Setting up the product" on page 10
●
"Intended use" on page 9
3.1.4.1 Placing the Product on a Bench Top
The R&S NRT2 is a small and lightweight product. You can stack the R&S NRT2 with
other products, but place the R&S NRT2 on top. In the following procedure, the weight
indication for stacking refers to the most common design of larger Rohde
& Schwarz
instruments. Verify the load suitable for your product before stacking.
To place the product on a bench top
1. Place the product on a stable, flat and level surface. Ensure that the surface can
support the weight of the product. For information on the weight, see the data
sheet.
2. CAUTION! Foldable feet can collapse. See "Setting up the product" on page 10.
Always fold the feet completely in or out. With folded-out feet, do not place any-
thing on top or underneath the product.
3. WARNING! A stack of products can fall over and cause injury. Never stack more
than three products on top of each other. Instead, mount them in a rack.
Stack as follows:
● If the products have foldable feet, fold them in completely.
● It is best if all products have the same dimensions (width and length). If the
products have different dimensions, stack according to size and place the
smallest product on top.
● Do not exceed the permissible total load placed on the product at the bottom of
the stack:
–
50 kg when stacking products of identical dimensions (left figure).
Preparing for Use