![Rohde & Schwarz 1430.0105K02 User Manual Download Page 63](http://html1.mh-extra.com/html/rohde-and-schwarz/1430-0105k02/1430-0105k02_user-manual_1477792063.webp)
System Settings
R&S
®
NRT2
63
User Manual 1178.5550.02 ─ 04
9.1.1
Network Settings
Access: [System]
> "Connections"
> "Network"
Contains the settings for integrating the R&S NRT2 in a network. There are two meth-
ods to establish a network connection between R&S NRT2 and computer:
► Connect both to a common network (infrastructure network).
► Connect R&S NRT2 and computer only over the switch (peer-to-peer network).
In this case, the use of a static IP address is recommended.
Connection errors can affect the entire network. If your network does not support
DHCP, or if you choose to disable dynamic TCP/IP configuration, assign a valid
address information before connecting the R&S NRT2 to the LAN. Contact your net-
work administrator to obtain valid IP addresses.
After integrating the R&S NRT2 into a network, you can set up the following connec-
tions:
●
Remote control connection to control the R&S NRT2 using SCPI commands.
See
●
Remote desktop connection for remote operation or file transfer.
See
Chapter 4.2, "Remote Operation"
The "Network" dialog is divided into the following tabs:
............................................................................................. 65
.................................................................................................65
............................................................................................. 66
Connections