Remote Control
R&S
®
NRT2
168
User Manual 1178.5550.02 ─ 04
SYSTem:COMMunicate:GPIB[:SELF]:ADDRess
<address>
Sets the address with which the R&S NRT2 can be addressed via the IEC/IEEE bus.
The address is factory-set to 12 and is not changed by a reset.
Parameters:
<address>
int_value
Range:
1 to 30
*RST:
12
Manual operation:
See
SYSTem:COMMunicate:INET[:SELF]:MODE
<state>
SYSTem:COMMunicate:NETWork[:IPADdress]:MODE
<mode>
Selects if the IP address is assigned automatically or manually.
Parameters:
<mode>
AUTO | STATic
AUTO
Assigns the IP address automatically, provided the network sup-
ports DHCP.
STATic
Enables assigning the IP address manually.
*RST:
AUTO
Example:
:SYST:COMM:NETW:IPAD:MODE AUTO
The IP address is assigned automatically.
Manual operation:
See
SYSTem:COMMunicate:INET[:SELF]:ADDRess
<IPaddress>
SYSTem:COMMunicate:NETWork[:IPADdress][:ADDRess]
<IPaddress>
Sets the IP address of the R&S NRT2 if the address mode is set to
STATic
.
Note: Choosing an invalid IP-Address may disturb the traffic on your LAN. If you are
not sure how to configure these settings, please ask your network administrator.
Parameters:
<IPaddress>
The four parameter form the IP address x.y.z.a.
Range:
0...255 for each part of the IP address
*RST:
This setting is not changed by *RST.
Example:
SYSTem:COMMunicate:NETWork:IPADress:ADDRess
108.0.0.255
Sets the IP address to 104.0.0.255
Manual operation:
See
SYSTem
