Rohde & Schwarz 1430.0105K02, User Manual

Page: 143 / 206

Remote Control
R&S
®
NRT2
143 User Manual 1178.5550.02 ─ 04
<msus>
Example: MMEM:STOR:STAT 0,'D:\USER\TEST1.ss'
Saves the current instrument setting in the
TEST1.ss
file in the
USER
directory on the internal hard disk.
Example: MMEM:STOR:STAT 4,'D:\user\test4.savrcl'
*SAV 4
Saves the
test4.savrcl
file in the
user
directory of the inter-
nal hard disk.
Usage: Setting only
11.11 OUTPut
OUTPut:LIMit:FAIL
......................................................................................................... 143
OUTPut:MODE<output>
................................................................................................. 143
OUTPut:RECorder<output>:LIMit:LOWer:RATio[:VALue]
....................................................144
OUTPut:RECorder<output>:LIMit:LOWer[:POWer]
............................................................ 145
OUTPut:RECorder<output>:LIMit:UPPer:RATio[:VALue]
.................................................... 145
OUTPut:RECorder<output>:LIMit:UPPer[:POWer]
.............................................................145
OUTPut:RECorder<output>:LIMit:LOWer:CCDF
................................................................146
OUTPut:RECorder<output>:LIMit:LOWer:RATio:RCOefficient
.............................................146
OUTPut:RECorder<output>:LIMit:LOWer:RATio:RFRatio
................................................... 146
OUTPut:RECorder<output>:LIMit:LOWer:RATio:RLOSs
.....................................................146
OUTPut:RECorder<output>:LIMit:LOWer:RATio:SWR
....................................................... 147
OUTPut:RECorder<output>:LIMit:UPPer:CCDF
................................................................ 147
OUTPut:RECorder<output>:LIMit:UPPer:RATio:RCOefficient
............................................. 147
OUTPut:RECorder<output>:LIMit:UPPer:RATio:RFRatio
....................................................148
OUTPut:RECorder<output>:LIMit:UPPer:RATio:RLOSs
..................................................... 148
OUTPut:RECorder<output>:LIMit:UPPer:RATio:SWR
........................................................ 148
OUTPut:LIMit:FAIL <mode>
Specifies the value which should be applied to output 1 if the measured value causes a
limit violation and the outout is in TTL mode (
OUTPut:MODE<output>
on page 143).
Parameters:
<mode> LOW | HIGH
HIGH
Corresponds to an output voltage of 2.5 V, if a limit is violated.
*RST:
LOW
Manual operation: See "Fail Voltage" on page 71
OUTPut:MODE<output> <mode>
Switches the operating mode of the I/O connector.
OUTPut