![background image](http://html1.mh-extra.com/html/omron/cx-process-monitor-plus-2/cx-process-monitor-plus-2_operation-manual_744195062.webp)
47
Connecting the PLC
Section 2-2
2-2
Connecting the PLC
The following three methods can be used to connect to the PLC. Regardless
of the connection method, the FinsGateway communications driver (embed-
ded version) is used.
Note
Host Link communications use FINS commands wrapped in header and ter-
minator data (i.e., SYSWAY-CV for FinsGateway). Host Link communications
(SYSMAC WAY) is set for the CPU Unit.
2-2-1
Connecting via Host Link
The personal computer uses the FinsGateway’s Serial Unit Driver to connect
to the peripheral or RS-232C port of the PLC via Host Link communications.
Note
1.
The Serial Communications Mode must be set to Host Link.
Host Link communications use FINS commands wrapped in header and
terminator data (i.e., SYSWAY-CV for FinsGateway). The peripheral bus
cannot be used.
2.
The FinsGateway Serial Unit Driver must be installed to enable connecting
the PLC via Host Link communications.
3.
The following Connecting Cables are used to connect the CX-Process Tool
(personal computer) to the PLC (CPU Unit or Serial Communications
Board/Unit).
Communications
network
FinsGateway
communications
driver
Contents
Host Link Network
(See note.)
Serial Unit Driver
Connecting to the peripheral or RS-
232C port of the PLC over Host
Link.
Controller Link Net-
work
CLK (PCI slot) Driver
(Not supported by Fin-
sGateway Version 2)
Connecting through the Controller
Link Support Board to a PLC with a
Controller Link Unit mounted.
Ethernet Network
ETN_UNIT Driver
Connecting through the Ethernet
Board to a PLC with an Ethernet
Unit mounted.
CX-Process
Monitor Plus
IBM PC/AT or
compatible
(9-pin male)
Loop Control Unit
CS1 CPU Unit
Peripheral
port
CS1W-CN226 or
CS1W-CN626
Connecting Cable
RS-232C Port
XW2Z-200S-CV
Connecting Cable
Connections to the Peripheral
Port of the CPU Unit
Connections to the RS-232C port of the CPU
Unit or Serial Communications Board or Unit
CX-Process
Monitor Plus
IBM PC/AT or
compatible
(9-pin male)
Loop Control Unit
CS1 CPU Unit
Summary of Contents for CX-Process Monitor Plus 2
