Voltage Transformer
5 - 7
– Vprim is measured and displayed.
– To save the measurement press K
E E P
R
E S U L T S
.
– Navigate to the "V sec" entry field.
– Enter the measured Vsec value either by turning the handwheel or by
entering this value with the numerical keys, and press E
N T E R
or the
handwheel to acknowledge your setting.
– The ratio is calculated and displayed.
– To stop the manual test, press the I/O (test start/stop). The test can now be
assessed.
– To repeat the test, first press B
A C K
T O
T
O P
, if applicable, and then C
L E A R
R
E S U L T S
.
To learn more about test assessment, refer to ”Test Assessment” on page 10-2.
Note:
Alternatively, it is possible to enter the manually measured value
into the test card after the test was stopped (for example, if the
measurement was carried out at a remote location).
Summary of Contents for CPC 100
