Mitsubishi Electric MR-JE-C, Instruction Manual

Page: 74 / 312

4. PARAMETERS
4 - 37
No./symbol/
name
Setting
digit
Function
Initial
value
[unit]
General
purpose
Communication
CP PS CP PS
PT29
*TOP3
Function
selection T-3 Set the DOG polarity.
_ _ _ x
(HEX)
_ _ _ x (BIN): Proximity dog input polarity
Select the proximity dog input polarity.
0: Dog detection with off
1: Dog detection with on 0h
_ _ _ x (BIN): External limit/Rotation direction input polarity
Select the input polarity of the SIG (External limit/Rotation direction
decision).
0: Normally open contact
1: Normally closed contact
_ _ x _ (BIN): For manufacturer setting
_ x _ _ (BIN): For manufacturer setting
x _ _ _ (BIN): Touch probe 1 input polarity
Select touch probe 1 input polarity.
0: Normally closed contact
1: Normally open contact
_ _ x _ For manufacturer setting 0h
_ x _ _ 0h
x _ _ _ 0h
Convert the setting value into hexadecimal as follows.
0
Initial value
BIN HEX
Setting
0
0
0 0 0
0
0
"Proximity dog input polarity" or "External limit/
Rotation direction input polarity"
Touch probe 1 input polarity
PT30
TPSTL
Touch probe
sensor -
Travel
distance
before stop
(lower four
digits) Set Touch probe sensor - Travel distance before stop.
Upper and lower are a set.
Set an address in hexadecimal.
When touch probe detection is latched, the remaining travel distance
changes to travel distance set with this parameter.
Setting address:
Upper four
digits
Lower four
digits
[Pr. PT30]
[Pr. PT31]
The unit can be changed to 10
STM
[μm], 10
(STM-4)
[inch], or [pulse] with the
setting of [Pr. PT01].
Setting range: 00000000h to 7FFFFFFFh
0000h
Refer to
Function
column
for unit.
PT31
TPSTH
Touch probe
sensor -
Travel
distance
before stop
(upper four
digits) 0000h
Refer to
Function
column
for unit.