Mitsubishi Electric MR-J4W2, Instruction Manual

Page: 90 / 542

4. STARTUP
4 - 15
4.5.1 Test operation mode in MR Configurator2
POINT
All axes will be in the test operation mode for the multi-axis servo amplifier.
Although only one axis is active in the mode.
When the test operation mode is selected with the test operation select switch
(SW2-1), the SSCNET III/H communication for the servo amplifier in the test
operation mode and the following servo amplifiers is blocked.
(1) Test operation mode
(a) Jog operation
Jog operation can be performed without using the servo system controller. Use this operation with
the forced stop reset. This operation may be used independently of whether the servo is on or off
and whether the servo system controller is connected or not.
Exercise control on the jog operation screen of MR Configurator2.
1) Operation pattern
Item Default value Setting range
Speed [r/min] 200 0 to max. speed
Acceleration/deceleration
time constant [ms]
1000 0 to 50000
2) Operation method
When the check box of "Rotation only while the CCW or CW button is being pushed." is
checked.
Operation Screen control
Forward rotation start Keep pressing the "Forward" button.
Reverse rotation start Keep pressing the "Reverse" button.
Stop Release the "Forward" or "Reverse" button.
Forced stop Click the "Forced stop" button.
When the check box of "Rotation only while the CCW or CW button is being pushed." is not
checked.
Operation Screen control
Forward rotation start Click the "Forward" button.
Reverse rotation start Click the "Reverse" button.
Stop Click the "Stop" button.
Forced stop Click the "Forced stop" button.