Miranda Kaleido-X, User Manual, Page: 89 / 407

Adding Multi-Viewers to a Cluster
81
IP addresses for all the multi-viewer systems that are on the same subnet as your PC are included in
the list.
3. If your PC and the multi-viewer you wish to add are on the same subnet, then you can select the multi-
viewer’s IP address from the list. Otherwise type the appropriate IP address in the box.
The multi-viewer is added to the System list.
4. Repeat from step 2 until you have added all the required systems to the cluster.
5. If further system configuration is required on the individual members of the cluster, start with the
current system (i.e. the one you are connected to). See “Configuring the System Representation” on
page 85, for detailed instructions on adding cards. Refer to “Routers & Kaleido-X” on page 265, and
“Tally Interface Devices” on page 311, for instructions on adding other routing and control devices.
6. Once you have completed the current system’s specific configuration, save it, and then connect to the
next cluster member you need to configure, by expanding the appropriate node and double-clicking
any card.
Note: The system type is automatically adjusted based on the actual target system.
Note: Each member of a cluster has its own database where both common information about the cluster
and information local to the individual cluster member are stored. Room and layout definitions are
automatically replicated to all cluster members, whereas the configuration for devices connected to a
specific system is only stored in this system’s database.