Miranda Kaleido-X, User Manual, Page: 68 / 407

60
Operation of the Monitor Wall
3
• In the case of a Kaleido-X16 , connect the keyboard to one of the USB ports on the multi-viewer. If two
displays are connected to the multi-viewer, then the resolution is applied to both. Alternatively, use a
keyboard connected to the Kaleido-RCP2 (if available).
• In the case of a KMV-3901/3911 , you can only connect a keyboard to the Kaleido-RCP2 (if available).
If two displays are connected to the multi-viewer, then the resolution is applied to both.
Enabling EDID Auto-Detection from the Monitor Wall
To enable EDID auto-detect for a display:
1. Right-click the monitor wall background, and then click Display Resolution on the shortcut menu:
2. Select the Use detected monitor resolution check box:
3. Click OK .
Note: If the keyboard is connected to a Kaleido-RCP2, the Keyboard attribute for the current RCP user must
have been set to “US” in XEdit, otherwise the shortcut may not work (i.e. it could be parsed and converted
to a special character, depending on the selected locale). In the case of a Kaleido-X, the shortcut will reset
the resolution on the active display (the one where the mouse pointer is located) and on the other display
connected to the same output card, if any.
Note: The monitor EDID auto-detect feature is enabled by default in order to facilitate the initial setup
of a Kaleido-X system. To avoid problems, Miranda recommends that you disable the auto-detect feature
once the initial setup is completed. If you later wish to replace one of the displays, re-enable the auto-
detect feature beforehand (remember to disable it once the new display is up and running).