Mart Cyclone 30 Series, Installation, Operation And Maintenance Manual, Page: 69 / 322

Installation 2 - 21
Standard Turntable Power Washer v. 4.0 The MART Corporation
5.2.2. Water (Input)
Refer to the specifications in the SBO form for correct water-line sizes. A 1/2-inch-
diameter (13 mm) water line is required for automatic water-fill and the optional Auto
Rinse Cycle (ARC).
Follow this procedure :
1. Install a water regulator , if incoming water pressure is greater than 125 PSI
(862 kilopascals). The regulator should regulate water pressure to 100-125
PSI (690-862 kilopascals). (
NOTE : The water regulator is not provided by
MART.)
2. Connect a 1/2-inch-diameter (13 mm) water supply line to the regulator or the
washer inlet. NOTE: The washer water supply inlet is a BRASS fitting. Do
not use Teflon tape if you have a plastic filter: use a liquid pipe dope. Refer
to the following figure for the connection location.
Fig. 2 - 7: Water Connection Location
Water
Supply
Inlet
(BRASS Fitting)
Rinse
Reservoir
Drain Plug
Water Filter
And
Regulator