Installation
2 - 1
Standard Turntable Power Washer v. 4.0
The MART Corporation
2
Installation
Purpose
This chapter gives operating instructions/procedures for installation and startup of the
MART Power Washer
. Correct installation of the washer is important for the following
reasons:
·
To ensure that the washer will function properly.
·
To ensure that placement of the washer on your shop floor will fit into
the workflow pattern.
·
To ensure that you have a valid warranty.
Prerequisites
Before you begin to install the power washer, be sure you have followed the
recommendations in this section.
q
Information
: Read the entire manual before installation.
q
Expert Help and Equipment
: For leveling, anchoring, installing,
and startup have the following on hand:
·
Qualified, trained personnel
·
Proper lifting equipment
·
Anchoring materials
·
Steel shims
·
Flue pipe
·
Auto steam exhaust (ASE) pipe
·
Rain cap(s)
·
Tools, including masonry drill
·
Voltmeter and amp meter
q
Steam-Exhaust
PVC Kit
: Order your kit through MART. Refer to
section
"Steam Exhaust (Output)"
in this chapter.
Summary of Contents for Cyclone 30 Series
