Mart Cyclone 30 Series, Installation, Operation And Maintenance Manual, Page: 187 / 322

7 - 8 Installation, Operations, and Maintenance Manual
The MART Corporation Standard Turntable Power Washer v.
4
.0
1.5. Troubleshooting
This section contains tables on the following problems:
·
Automatic lubrication system fault light is ON
Problem: Automatic lubrication system fault light is ON
Check This: Probable Cause(s)
Grease Pump Empty (refill grease reservoir)
Control valve Stuck (replace)
Air-pressure Not in the 75-100 PSI [1000-1400 kg/sq cm]
range (check air-supply system)
Electric solenoid Burned out (replace)
Grease dividing valve Air bubble bled all air out of the system
Stuck (disassemble, clean, & bleed)
Power Verify that the controller has power
Step #4 in controller Time set too short
program
Fig. 7 - 2: Troubleshooting: Automatic Lubrication System Fault Light Is ON
NOTE:
Bearing Lubrication
Bearing lubrication is critical : Before making any changes to the lubrication cycle, refer
to chapter " Advanced Operations: Process-Control" and to chapter "Maintenance” for
information on required lubrication.
NOTE : Use Lubriplate 1444 grease ONLY .
Bearings are receiving too much grease : Adjust the lubrication duration. Adjust
the Lube Cycle Counter to a higher number of cycles. See the Operations
section for instructions on changing the controller program.
Bearings are receiving too little grease : Lengthen the lubrication duration. Set
the Lube Cycle Counter to 1 so that a lubrication cycle is run every washer
cleaning cycle. Check the system for proper operation. See the
Operations
section for instructions on changing the controller program.