Mart Cyclone 30 Series, Installation, Operation And Maintenance Manual, Page: 160 / 322

5 - 24 Installation, Operations, and Maintenance Manual
The MART Corporation Standard Turntable Power Washer v. 4.0
16. Replace the front reservoir cover .
17. Turn the main power supply ON .
NOTE : The power washer controls will automatically fill the
reservoir with the correct amount of water.
18. Perform a chemical-titration test , and add chemical as indicated by the test
results.
19. Allow solution to heat up to operating temperature before running a wash
cycle.
3.3. Heating Elements (Clean - electric only)
This procedure applies to electrically heated power washers only .
NOTE : Maintenance of heating elements may need to be done
more often than sludge clean-out, or cleaning of the heat
exchanger and suction tube.
Follow this procedure :
WARNING! Turn the main power supply OFF and allow
solution to cool to room temperature before cleaning heating
elements.
1. Remove the front reservoir cover .
2. Pump the solution into holding barrels .
NOTE : Empty solution to a level just below the heating elements.
3. Position the door at a 180
°
angle from the cabinet frame.
4. Remove the false floor .
5. Wire-brush or pressure wash the heating element(s) . Refer to the following
figure.
6. After cleaning the heating element(s), pump solution back into the reservoir.