Mart Cyclone 30 Series, Installation, Operation And Maintenance Manual, Page: 183 / 322

7 - 4 Installation, Operations, and Maintenance Manual
The MART Corporation Standard Turntable Power Washer v.
4
.0
The air solenoid valve repeatedly cycles open and closed for a timed duration. Each
opening and closing of the solenoid valve causes the grease pump to make one stroke.
The grease is pumped from the reservoir to the grease-dividing valve. The dividing
valve proportions the proper amount of grease flow from the pump to each bearing.
Grease lines carry the grease flow from the dividing valve to each of the lubrication
points:
· Turntable upper and lower bearings
· PBM swivel bearings
An electronic programmable controller inside the control panel mounted next to the
grease pump controls the automatic lubrication system. A counter in the controller
counts washer cleaning cycles and initiates a lubrication cycle after a preset number of
cleaning cycles. (The factory pre-set is 1 cycle, which means that the automatic
lubrication system will start every wash load.)
The duration of the lubrication cycle (which controls the number of cycles of the dividing
valve and, therefore, the amount of grease pumped during a lubrication cycle) is
programmable in the controller. The factory preset is for 5 cycles.
1.2. Installation
The automatic lubrication system arrives factory-installed.