Installation
2 - 17
Standard Turntable Power Washer v. 4.0
The MART Corporation
Fig. 2 - 4: Mounting the Combustion Burner (Up to 400,000 and 800,000 BTU)
For combustion burners up to 400,000 BTU and 800,000 BTU
,
follow this procedure
(refer to the previous figure):
1. Install the ceramic-fiber rope gasket supplied with the burner: Wind it in a
spiral on the face of the burner flange, inside the bolthole circle, in a single
layer. Cut off the excess rope.
NOTE:
The rope may be held in place by
masking tape or RTV adhesive.
2. Insert the burner nose into the end of the heat exchanger. Align the
boltholes.
3. Install 4 burner mounting bolts.
CAUTION:
Do NOT over-tighten these
bolts to the point where the burner flange distorts!
Now go to the
"Burner Fuel and Electrical Connection"
section.
Summary of Contents for Cyclone 30 Series
