7 - 12
Installation, Operations, and Maintenance Manual
The MART Corporation
Standard Turntable Power Washer v.
4
.0
5. Install the
wiring
between the Clean Machine and the washer as follows:
·
Run the sealtite
conduit
, located at the back of the
washer
,
near the pump, to the
control box
on the
Clean Machine.
·
Hook up the
conduit
to the
box
through the bottom of the
box.
·
Install the
6 wires
to the
electrical box
as follows:
Red Wire---------------- #10
Green Wire------------- Ground
Pink Wire --------------- SK
White Wire ------------- Neutral
Black Wire-------------- Contactor
Black Wire-------------- Contactor
6. Place an approved
container
at the
outlet
of the
skimmer assembly
to collect
waste and tramp oils.
WARNING! Fill the Clean Machine's separator tank BEFORE
you turn on the heat!
7. Set the
temperature controller
(aquastat), located on the side of the Clean
Machine's separator tank, to 170
°
F (77
°
C). The heater replaces heat lost
when the solution is in the tank -- it is NOT designed to heat solution from
ambient temperature.
NOTE
: Leave the heating loop
ON
for the Clean Machine's
separator tank even when the washer is not in operation.
8. Verify that part of the
Clean Machine's pump flow
is directed to the washer
(to agitate the solution and keep contaminates in suspension).
9. Verify that the
remainder of pump output
is directed to the Clean Machine's
separator tank
.
Summary of Contents for Cyclone 30 Series
