Mart Cyclone 30 Series, Installation, Operation And Maintenance Manual, Page: 67 / 322

Installation 2 - 19
Standard Turntable Power Washer v. 4.0 The MART Corporation
WARNING! Do not allow gas pressure in excess of 12.0 WCI to
be applied to the combination gas valve inlet, or damage may
occur. If gas pressure in the branch line supplying the burner
is above 12.0 WCI, then a lock-up type gas pressure regulator
of the correct size and range MUST be installed.
4. Turn ON the main gas supply .
WARNING! Do NOT try to start the burner at this time! NEVER
operate the burner unless the washer reservoir is at "full-
water" level. You will start the burner later, during the startup
procedure.
5. Perform leak tests at all fuel pipefittings and joints, including all connections
on the burner, and all piping installed to the burner. To do this, smear a
solution of soap and water around all fittings and look for bubbles. If you see
bubbles, the fittings and joints are not tight, and are leaking.
6. Turn OFF the main gas supply.
Electric Heat Source
The electric heating elements have already been installed at the factory. No further
connection procedures are required.
Steam Heat Source
For proper connection of the steam heat source, refer to the specifications in the SBO.
Follow this procedure :
1. Install the steam solenoid on the upstream side (the right side of the washer)
of the steam heat exchanger, as shown in the following figure.
2. Install the steam trap on the downstream side (the left side of the washer) of
the steam heat exchanger, as shown in the following figure.