Mart Cyclone 30 Series, Installation, Operation And Maintenance Manual, Page: 109 / 322

3 - 10 Installation, Operations, and Maintenance Manual
The MART Corporation Standard Turntable Power Washer v. 4.0
2.5. Closing and Locking the Door
CAUTION! Close the door slowly! Be especially careful if the
floor is wet or slippery!
Position Lock To close the door, rotate the position-lock handle upward to
release the lock from the first or second position. Then, hold the
handle up and push the door
slowly toward the cabinet, until it
shuts.
The position-lock handle is located at the bottom of the door.
Refer to Fig. 3-4.
Door Latch Swing the latch hook toward the door handle.
Push the latch handle toward the washer cabinet to close and lock
the latch. Refer to Fig. 3-3.
2.6. Verifying Wash Temperature
Check the water temperature gauge again to verify that the washer has reached the
minimum operating temperature specified by your process-control instructions before
setting the timer. Refer to Fig. 3-2 for the gauge's location.
If the gauge still has not reached the specified operating temperature, refer to chapter
"Troubleshooting."
WARNING! Do NOT operate the washer unless it has reached
minimum operating temperature. Excessive foaming and
additional water loss may occur.