Mart Cyclone 30 Series, Installation, Operation And Maintenance Manual, Page: 140 / 322

5 - 4 Installation, Operations, and Maintenance Manual
The MART Corporation Standard Turntable Power Washer v. 4.0
2. Performing Maintenance and Common
Washer Adjustments
This section gives maintenance instructions and common washer adjustments for items
listed in Fig. 5-1, except sludge monitoring and clean-out, which is in section 3. Items
are grouped by washer systems and assemblies.
2.1. Pumps and Power Blast Manifold (PBM)
Assembly
This section describes maintenance procedures for the following:
·
Wash pump intake filter (inspect/clean)
·
PBM swivel joint (grease; Lubriplate 1444)
· PBM nozzles (inspect/monitor)
· PBM swivel jam nut (inspect/adjust)
·
Amperage draw at wash pump (measure)
·
Upper manifold bearing (grease; Mobilith AW2)
·
Wash pump and pump motor (grease; Mobilith AW2)
·
Wash pump couplings (inspect)
2.1.1. Wash Pump Intake Filter (Inspect/Clean)
Follow this procedure (refer to the following figure):
CAUTION! Do not remove the pump intake filter box from the
reservoir.
1. Remove the front reservoir cover.
2. Clean the pump intake filter box with a stiff-bristle wire brush. (The filter box
is located at the bottom-front-left corner of the reservoir.)
3. Run the brush across the top, back, and right hand-side of the filter box to
remove sludge and gasket material.
4. Replace the reservoir cover.