Mart Cyclone 30 Series, Installation, Operation And Maintenance Manual, Page: 151 / 322

Maintenance 5 - 15
Standard Turntable Power Washer v. 4.0 The MART Corporation
Making Adjustments (see chapter "Installation/Power-Up Procedure/Water-Level
Control" for more information)
If the water level is more than 1/8" above or below the water-level indicator , follow
this procedure :
1. Remove solution until the solution level is below the set-point.
2. Let the washer fill automatically and shut off.
3. If the water level is more than 1/8" inch above or below the water-level
indicator,
you will need to adjust the cam on the float rod. Follow the steps
below.
Turn the power OFF.
Remove the float-control box cover.
4. Mark the current location of the cam on the float rod with a marker or a piece
of tape before making any adjustments.
If the water-level measurement you made is higher than the indicator,
you will need to move the cam up the float rod by the difference
between the indicator and the measured value
If the measurement is lower than the indicator, you will need to move
the cam down the float rod by the difference between the indicator
and the measured value.
Measure the distance to the new position and mark it on the float rod.
Next, loosen the two set-screws on the cam with an Allen wrench.
Finally, slide the cam to the new location, and re-tighten both set-screws.
5. Turn power on to the washer and test the new level by allowing the washer to
fill to the old set-point.
NOTE: It will be necessary to remove water from the washer if the new level
is lower than the new set-point.
Verify that the set-point level is correct. If necessary, repeat the above steps
until the set-point level is at the indicator, plus or minus 1/8" inch.
6. Replace the cover on the float box and tighten the four screws.