Mart Cyclone 30 Series, Installation, Operation And Maintenance Manual, Page: 158 / 322

5 - 22 Installation, Operations, and Maintenance Manual
The MART Corporation Standard Turntable Power Washer v. 4.0
3. Sludge Monitoring and Clean-Out
This section describes maintenance procedures for the following:
·
Sludge (monitor and clean out)
·
Heat exchanger and suction tube (clean)
·
Heating element(s) (clean - electric only)
Generally, when you clean out sludge, clean the heat exchanger and suction tube as
well as the heating elements (if you have electric heat), since all require that the washer
be emptied.
NOTE : Maintenance of heating elements may need to be done
more often than sludge clean-out, or cleaning of the heat
exchanger and suction tube.
WARNING! Do not stand or walk on the false floor inside the
cabinet, or on the reservoir cover.
3.1. Sludge Monitoring
To monitor and measure sludge accumulation on the bottom of the reservoir, follow this
procedure :
1. Remove the front-reservoir cover.
2. In the front-right corner of the reservoir, push a long stick vertically down to
the reservoir floor.
3. Remove the stick.
4. Observe the sludge mark on the stick.
5. If 4 inches (10 cm) of sludge is indicated, clean out the washer.
3.2. Sludge Clean-Out and Heat Exchanger/
Suction Tube (Clean)
Clean the heat exchanger and suction tube when you clean out sludge, since both
maintenance procedures require that the washer be emptied. If your washer uses