Mart Cyclone 30 Series, Installation, Operation And Maintenance Manual, Page: 200 / 322

Options 7 - 21
Standard Turntable Power Washer v.
4
.0 The MART Corporation
3.3. Operations
WARNING! The minimum inside diameter of a part that can be
cleaned by the center manifold is 5 inches.
To operate the center manifold, follow this procedure :
1. Verify that the manifold is up near the roof of the cabinet.
The center manifold has an automatic Home (or up ) position
controlled by a limit switch at the top of the superstructure.
2. Place the part to be washed in the center of the turntable. (A special fixture
may be needed to keep the part centered on the turntable and properly
aligned with the center manifold.)
WARNING! Be sure the part is centered properly, so that the
center manifold does not hit the part!
3. Set the center manifold mode selector switch , located on the washer's
control panel, to one of the following:
· Man: Turns auto mode OFF. Activates the manifold jog
push button, which lets you manually control the down/up
position of the center manifold.
·
Auto: Returns the manifold to the home position, and sets
automatic cycle as part of the wash/rinse cycle. A light on
the control panel illuminates each time the center manifold
strokes during operation. The center manifold works with
the power blast manifold (PBM).
·
OFF: Returns the manifold to the home position, and
disables auto cycle.
Refer to chapter "Basic Operations" for more information on loading and unloading
parts.