Mart Cyclone 30 Series, Installation, Operation And Maintenance Manual, Page: 152 / 322

5 - 16 Installation, Operations, and Maintenance Manual
The MART Corporation Standard Turntable Power Washer v. 4.0
NOTE: If your washer has a rinse system, once operations
have started water levels in the washer can be higher than the
set-point water level. This happens whenever the washer
automatically uses the rinse-bank for longer rinses.
To verify the correct set-point water level after operations have
started, you must allow the washer to fill to the set-point. You
can check this by observing the position of the float cam
relative to the limit switches in the float box. (Refer to Fig. 1-3:
Float-Level Mechanics) If the cam is higher than the set-point,
you will have to remove solution from the washer and allow
the washer to fill to the set-point to check set-point water level.
REMEMBER!! NEVER CHANGE THE POSITION OF THE LIMIT
SWITCHES -- they are pre-set. For more information on the limit
switches, refer to chapter "Overview."
2.3.2. Water Solenoid Valves (Clean or Replace)
Disassemble the water solenoid valves, and clean or replace the diaphragms with re-
build kits.
Refer to your vendor-supplied cut sheet for instructions.
Fig. 5 - 9: Solenoid Valves
Air
Solenoid
Valve
Compressed
Air
Inlet
Rinse
Reservoir
Drain Plug
Rinse
Water
Solenoid
Valve