7 - 62
Installation, Operations, and Maintenance Manual
The MART Corporation
Standard Turntable Power Washer v.
4
.0
11.4.
Maintenance
Every 1100 hours of operation:
·
Oil
the skimmer motor with a standard electric-motor oil, suitable for
small electric motors. For example, 10W-50 SAE oil.
Refer to the vendor-supplied cutsheet for oil points.
During sludge clean out:
·
Clean
the wheel and frame. If necessary, remove the skimmer
assembly and box cover to clean sludge out of the box.
Refer to chapter
"Maintenance"
for more information on sludge clean out.
11.5.
Troubleshooting
This section contains tables on the following problems:
·
Skimmer-wheel does not skim
Problem:
Skimmer-wheel does not skim
Check This:
Probable Cause(s)
Drain trough
Clogged
Blades
Not contacting wheel:
Bend to adjust
Replace if worn
Wheel
Not turning (check/tighten shaft nuts)
Motor
Motor not turning (115 V):
Fuse needs to be replaced
Wires need to be tightened
Motor needs to be replaced
Fig. 7 - 32: Troubleshooting: Skimmer-Wheel Does Not Skim
Summary of Contents for Cyclone 30 Series
