Mart Cyclone 30 Series, Installation, Operation And Maintenance Manual, Page: 192 / 322

Options 7 - 13
Standard Turntable Power Washer v.
4
.0 The MART Corporation
2.3 Operations
The Clean Machine system is designed to operate when the washer is in use, or after
hours, when the washer is in "shut-down" ( off ) mode.
NOTE: The maximum separation of sludge and oils will occur after
a few days of washing heavily soiled parts.
To operate the Clean Machine, follow this procedure :
1. Set the Clean Machine's selector switch , located on the washer's control
panel, to one of the following:
·
Manual: Activates the Clean Machine's pump. It will run
continuously.
·
Off: Turns the Clean Machine's pump off.
· Auto: Automatically activates and runs the Clean Machine
according to the program set for circuit #2 of the 7-day
clock.
NOTE : You must program the 7-day clock's circuit #2
for ON/OFF times, and set the Clean Machine's
selector switch to auto.
2. After you activate the Clean Machine, verify the following:
·
The oil skimmer is rotating clockwise.
·
Water is being discharged from the bottom of the
hydrocyclone.
NOTE : To adjust the control valve on the Clean Machine pump,
open the valve completely . Then, if you notice that water overflows
from the oil skimmer tank into the sludge tank, slowly close the 1
1/2-inch-diameter (3.8 cm) valve just until water no longer
overflows. Open the gauge valve on the cyclone, and note the
pressure reading. The reading should be more than 15 PSI for the
best separation. Close the gauge valve to protect the gauge.
2.3.1 Clean-Machine Operation: Frequency
The amount of contaminants on the parts to be washed will determine how often you
should operate the Clean Machine.