Mart Cyclone 30 Series, Installation, Operation And Maintenance Manual, Page: 150 / 322

5 - 14 Installation, Operations, and Maintenance Manual
The MART Corporation Standard Turntable Power Washer v. 4.0
2.3. Water-Level Control System
This section describes maintenance procedures for the following:
·
Float assembly (inspect/clean)
·
Water solenoid valves (clean or replace)
2.3.1. Float Assembly (Inspect/Clean)
Inspect/Clean
Inspect the float assembly periodically. The single-ball float system normally requires
little or no cleaning -- however, under some operating conditions, you may have to clean
the operating rod and float ball.
Refer to the following figure to locate these parts:
·
Check the cam set screws for tightness.
·
Check the float ball to rod connection for tightness.
·
Clean the float ball , if necessary.
Fig. 5 - 8: Float Assembly