
Maintenance
5 - 3
Standard Turntable Power Washer v. 4.0
The MART Corporation
1. Service Schedule
Your washer comes with a maintenance
Service Schedule
along with the MART Power
Washer Manual located in a white pouch inside of the main electrical-control-panel. The
following figure shows part of the schedule, organized by hours of washer operation.
Maintenance procedures for items in the schedule follow, and are grouped by washer
systems and assemblies.
Use the
Hour Meter
on the washer's control panel to
schedule maintenance by hours of operation.
Service Schedule
Frequency
Date
Technician
8 Hours (At the end of every shift)
Wash Pump Intake Filter (inspect/clean)
__________
________
(NOT Cyclone 30’s and Tornado 40’s only)
Turntable Bearings (grease; Lubriplate 1444)
__________
_________
PBM Swivel Joint (grease; Lubriplate 1444)
__________
_________
Sludge Level (monitor)
__________
_________
40 Hours (Weekly)
PBM Nozzles (inspect/monitor)
__________
_________
Chemical Concentration (test)
__________
_________
Slip Clutch/Torque Limiter (inspect)
__________
_________
160 Hours (Monthly)
PBM Swivel (inspect/adjust)
__________
_________
Air Intake - Burner Blower Motor (clean)
__________
_________
Amperage Draw at Wash Pump(s)(measure)
__________
_________
Turntable Drive Bearings (grease; AW2)
__________
_________
Upper Manifold Bearing (grease; AW2)
1100 Hours (6 Months)
(Cyclone 30’s and Tornado 40’s only)
Turntable Bearings (grease; Lubriplate 1444)) __________
_________
Voltage at Power Distribution Block (measure) __________
_________
Door Bearings (grease; AW2)
__________
_________
Wash Pump and Pump Motor (grease; AW2)
__________
_________
Float Assembly (inspect/clean)
__________
_________
ASE Blower Motor (oil)
__________
_________
Burner Blower Motor (oil)
__________
_________
Water Solenoid Valves (clean or replace)
__________
_________
Wash Pump Couplings (inspect)
__________
_________
Fig. 5 - 1: Service Schedule
Summary of Contents for Cyclone 30 Series
