LS ELECTRIC L7NHF Series, User Manual

Page: 18 / 409

1. Product Configuration
1-4

L7NHF Drive (3.5kW)
Analog monitor connector
Connector to check analog output
signals.
Node address setting switch
Switch to set the node address of the
drive.
You can set the node addresses from 0
to 99.
USB connector (USB)
This connector is used to communicate
with a PC.
EtherCAT communication input port
(ECAT IN)
EtherCAT communication output port
(ECAT OUT)
Safety connector (STO)
This connector connects safety devices.
- If a safety device is not used, be sure to
install the safety jump connector before use.
Input/output signal connectors (I/O)
This connector is for sequence input/output
signals.
Encoder connector (ENCODER)
This connector connects to the encoder
installed in the servo motor.
Encoder connector 2 (ENCODER2)
Connector used to connect the encoder
(sensor) installed in the external equipment.