Lenovo Flex System x220, Installation And Service Manual

Page: 309 / 714

Critical - Voltage
SNMP Trap ID
1
CIM Information
Prefix: PLAT ID: 0494
User Response
Use one of the following procedures:
– If the specified sensor is Planar 3.3V or Planar 5V, replace the system board.
– If the specified sensor is Planar 12V, check the Chassis Management Module or Flex System
Manager event log for power-supply-related issues, and resolve those issues. If the problem
remains, replace the system board.
• 80010b01-3701ffff : Numeric sensor Inlet Temp going high (upper non-recoverable) has asserted.
has asserted.
The inlet temperature has exceeded its specified threshold. The compute node has initiated a hard
shutdown.
May also be shown as 80010b013701ffff or 0x80010b013701ffff
Severity
Error
Serviceable
Yes
Automatically notify support
No
Alert Category
Critical - Temperature
SNMP Trap ID
0
CIM Information
Prefix: PLAT ID: 0498
User Response
Complete the following steps until the problem is solved:
1. Check the Chassis Management Module or Flex System Manager event log for any fan- or
cooling-related issues.
2. Make sure that the airflow at the front and rear of the chassis is not obstructed and that fillers
are in place and correctly installed.
3. Make sure that the room temperature is within operating specifications.
• 80010b01-3702ffff : Numeric sensor Pen Inlet Temp going high (upper non-recoverable) has
asserted.
The PEN inlet temperature has exceeded its specified threshold. The compute node has initiated a
hard shutdown.
May also be shown as 80010b013702ffff or 0x80010b013702ffff
Chapter 6
.
Troubleshooting
301