Konica Minolta Drypro 832, Service Manual

Page: 459 / 530

Chapter 17 Troubleshooting
17-71
Setting the Maintenance
Schedule
(ELAPSED TIME,
PRINTED SHEETS)
Setup the maintenance schedule.
If you do not have notes on the maintenance schedule (elapsed time, printed
sheets)
1. Calculate an appropriate value for the elapsed time and printed sheets from the
installation date, first scheduled maintenance date, and daily film output status for
the facility, refer to
“15.14 Maintenance Schedule (Page 15-31)” , and set the
values.
If you have notes on the maintenance schedule (elapsed time, printed sheets)
1. Refer to “15.14 Maintenance Schedule (Page 15-31)” , and enter the elapsed time
and printed sheets values from your notes.
Caution
If the Lispl-832 is connected, set the Lispl-832 in the same way.
Enter the label of the
control BOX.
Refer to “ Work after replacing the exposure unit (Page 8-5)” in the “8.2 Replacing Exposure
Unit” , re-enter the product setup items according to the label attached to the control BOX.
For PRODUCT SETUP, refer to “15.17 Product Setup (Page 15-37)” .
Set the image writing
position
Refer to “14.2 Checking and Adjusting Image Data Writing Position (Page 14-13)” , re-enter the
product setup items according to the label attached to the exposure unit.
For PRODUCT SETUP, refer to “15.17 Product Setup (Page 15-37)” .
Setting SIZE FINE
TUNING (H) SIZE FINE
TUNING (V) SIZE FINE
TUNING (Requested
Size)
Set each value for SIZE FINE TUNING.
If you do not have notes on setting values
1. Refer to “14.3 Checking and Fine Tuning the Print Size (Page 14-17)” , and adjust
the SIZE FINE TUNING (H) and SIZE FINE TUNING (V).
2. Refer to “15.17 Product Setup (Page 15-37)” and adjust SIZE FINE TUNING
(requested size).
If you have notes on setting values
1. Refer to “15.17 Product Setup (Page 15-37)” and enter the values from your notes
into SIZE FINE TUNING (H), SIZE FINE TUNING (V), and SIZE FINE TUNING
(requested size).
Set the correction Refer to “14.1.1 Density Correction (Page 14-3)” , re-enter the correction items according to the
label attached to the control BOX.
Note
There is no need to print here.
Sub Scan
OFFSET
position
adjustment
Main Scan
OFFSET
position
adjustment
Gain value
Phase value
Sub phase value
Sub gain value
Offset value