Konica Minolta Drypro 832, Service Manual

Page: 272 / 530

Chapter 14 Setting and Adjustment
14-16
14.2.3 Adjusting Sub Scan OFFSET (Vertical) Writing Position
If the unexposed portion at the end of the film is not 2mm, adjust the Main Scan OFFSET (lateral) writing position.
1
Click the [PRODUCT SETUP] button under “SERVICE INFO.”.
The “PRODUCT SETUP” window appears.
2
Enter the serial number of this product in “SERIAL NO.”.
3
Enter the length of the unexposed portions
measured in
“14.2.1 Checking Image Data
Writing Position (Page 14-13)” in the “VD
OFFSET” entry field after calculating using the
following formula.
Example: C = 5.0 mm
•
2.0 - 5.0 = - 3.0
Result: Enter a numeric value of VD OFFSET from which
“300” is subtracted.
4
Click the [SAVE] button.
5
Click the [BACK] button.
The “PRODUCT SETUP” window is closed. Then you will return to the Maintenance Menu window.
6
Perform “14.2.1 Checking Image Data Writing Position (Page 14-13)” again and check that the
image writing position has been properly adjusted.
This is the end of the process of adjusting the Sub Scan OFFSET (vertical) writing position.
Caution
If it was not adjusted properly, perform “14.2.3 Adjusting Sub Scan OFFSET (Vertical) Writing
Position (Page 14-16)” again.