4
Operation
Drive-Mode
4
4
5
KEB COMBIVERT F5-M / S
Name: Basis
17.05.04
Section
Page
Date
©
KEB Antriebstechnik, 2002
All Rights reserved
Chapter
To leave the Drive-Mode, the keys ÑFUNCì and ÑENTERì must be pressed
simultaneously for approx. 3 seconds while being in status ÑStopì! The unit jumps
back into the mode from where the Drive-Mode was started.
START
FUNC.
SPEED
ENTER
F/R
STOP
START
STOP
FUNC.
SPEED
ENTER
F/R
START
STOP
START
STOP
FUNC.
SPEED
ENTER
F/R
START
STOP
Stop
Run
ud. 9 = 4 or 5
Start
4.4.6 Leaving the Drive-
Mode
FUNC.
SPEED
ENTER
F/R
START
FUNC.
SPEED
ENTER
F/R
STOP
START
STOP
approx. 3 sec.
Stop
Leaving
Drive-Mode
4.4.7 Further Settings
With the Drive-Mode operating mode (ud.9) the setpoint sources and the conditions at
starting/stopping can be specified. As setpoint source serves either the keyboard in
the Drive-Mode as described under 4.4.3 or the setpoint source selected under
parameter oP.0. Refer to 4.4.5 to learn about the different operating conditions at
starting / stopping.
The status at starting / stopping (Bit 2 and 3) are only accepted after a restart the
drive mode !
To avoid undefined conditions, it must be ensured that the minimum speeds (oP.6,
oP.7) is set to 0 rpm at the values ud.9 bit 2, 3 = 1 or 2 .
Bit 3 Bit 2 Bit 1 Bit 0 Funktion ud.9
x
x
x
0
Set value setting by keyboard
x
x
x
1
Set value setting by set value source oP.0
x
x
0
x
set value is 0-limited (negativ values = 0)
x
x
1
x
absolut set value settings
0
0
x
x
LS => run
0
1
x
x
0 rpm => run
1
0
x
x
LS => 0 rpm => run
1
1
x
x
reserved