6
6
1
25
KEB COMBIVERT F5-M / S
Name: Basis
12.05.04
Section
Page
Date
©
KEB Antriebstechnik, 2002
All Rights reserved
Chapter
Functional Desription
Operating and Unit Data
6.1.7 Description of Sy (System) - Parameter
Adr.
min
max
default
0006h
1
-
1
239
0
Sy. 6
Inverter address
With Sy.6 the address is adjusted under which the inverter is addressed by ÑCOMBIVISì or another control. The possible
values are between 0 and 239, the default value is 1. If several inverters are operated simulaneously on the bus, it is
absolutely necessary to assign different addresses, since otherwise communication problems arise because several
inverters may responded at the same time. The development info DIN 66019II protocol (C0.F5.01I-K001) contains
further information.
Adr.
min
max
default
0002h
1
hex
-
9999
0000
Sy. 2
Inverter identifier
A unique number is assigned to each type of frequency inverter which identifies the hard- and software. This value is
used for example by COMBIVIS to load the correct configuration files. Sy.2 kann mit dem angezeigten Wert beschrieben
werden (z.B. zur Identifikation von Downloadlisten).
Adr.
min
max
default
0003h
1
P-ID
-
255
-255
Sy. 3
Power unit code
On the basis of the power circuit identification the control recognizes the used power circuit respectively a change of the
power circuit and adjusts certain parameters accordingly. To accept a new P-Id enter positive values (see chap. 9
ÑE.Puchì).
Adr.
min
max
default
0007h
1
-
5
6
0
Sy. 7
Baud rate ext. bus
Following values are possible for the baudrate of the serial interface:
Parameter value
Baudrate
0
1200 baud
1
2400 baud
2
4800 baud
3 (default)
9600 baud
4
19200 baud
5
38400 baud
6
55500 baud
If the value for the baudrate is changed over the serial interface, it can only be changed again by way of the keyboard
or after adapting the baudrate of the master, since no communication is possible in the case of different baudrates
between master and slave.
If problems occur during the data transmission, select a baudrate up to max. 38400 baud.